Skip to content
$69 inspection — credited back in full when you book the repair.
Top ChimneySweeps(816) 573-3499

Gas Fireplace Repair in Kansas City

$69 inspection — credited back in full when you book the repair

Gas fireplace repair covers the ignition and gas train — pilot assemblies, thermocouples and thermopiles, ignition modules, gas valves, blowers and door glass — on direct-vent, B-vent and vent-free units.

When you need this

  • Pilot lights but the main burner will not come on
  • Pilot will not stay lit when you release the knob
  • The remote or wall switch does nothing
  • You can smell gas — leave the house and call the gas company first, then us
  • Sooting on the glass or on the logs
  • Blower rattling, screeching, or not running
  • Glass cracked or the gasket failed

What the visit includes

  • Full gas train diagnosis with a manometer — inlet and manifold pressure measured, not guessed
  • Thermocouple and thermopile testing under load in millivolts
  • Pilot assembly cleaning and adjustment
  • Ignition module, valve, blower and switch replacement
  • Log set repositioning to manufacturer spec — misplaced logs are a common cause of sooting
  • Combustion and spillage check before we leave
Chimney technician kneeling on a drop mat servicing the valve train under a factory-built gas fireplace, with the ceramic log set and burner visible above
Gas service call: valve train, pilot assembly and burner checked with the lower louvre off.

Every photo on this site is our own work. We do not use stock photography.

What drives the price

We publish what moves the number rather than a single figure, because a quote that turns out to be low helps nobody.

  • Which component failed — a thermocouple is a modest part, a gas valve is the expensive one
  • Whether parts are still made for the unit; discontinued models sometimes need a universal conversion
  • Direct-vent versus vent-free versus B-vent, which changes the diagnostic path
  • Whether the fault turns out to be venting rather than the appliance

Why it matters

Gas appliances fail toward carbon monoxide. A blocked or disconnected vent, a cracked heat exchanger or a badly adjusted burner can spill combustion products into the room, and CO has no smell. This is not a category to keep nursing along.

Questions we get asked

My pilot keeps going out. What is that usually?

Most often a failing thermocouple or thermopile — it stops generating enough millivolts to hold the safety valve open. It is a common and inexpensive repair. Occasionally it is a draft problem instead, which is why we measure rather than just swap the part.

Do you work on vent-free units?

Yes. They need particular attention to the oxygen depletion sensor, and we will tell you honestly if the unit is one that should be replaced rather than repaired.

I smell gas. What should I do?

Do not switch anything on or off. Leave the house and call Spire from outside. Once the gas company has made it safe, we will handle the appliance repair.

Book the $69 inspection

Tell us what the chimney is doing and we will come and look. Credited back in full when you book the repair — or call (816) 573-3499 and we will take the details on the phone instead.

Prefer to type? Leave your details and we will come back to you. For anything urgent, calling is faster.

Give us a phone number or an email — either is fine, we just need one way to reach you.

(816) 573-3499